KEBA

Keba KETOP C50 R/73810/06 KEBA PANEL OPERATOR DISPLAY

Product features

• 2 incremental encoder inputs

with 12- or 32-bit resolution

• 2 latch inputs as sink or source input

• Electronic parameter chip

Short description

The MM 240/A is an incremental encoder of the KeConnect C2 product line. This module is attached directly to a CPU

module or can be operated with all KEBA controls by means of bus couplers.

MM 240/A features

• Position measurement: Forward/backward counter of increments by means of tracks A and B

• Single, double, quadruple evaluation

• 32-bit resolution

• Speed measurement through sampling with internal time basis

• Rotary encoder monitoring via zero track information

• Latch function of the counter status via an external latch input 24 V (sink and source)

• Latch function of the counter status via zero pulse

• Sensor failure monitoring of tracks A, B and zero

Incremental encoder

inputs

Number of inputs 2

Resolution 32 bit

Galvanic isolation No

Max. encoder frequency 250 kHz (differential)

Evaluation Single, double and quadruple evaluation configurable, counter function with and without direction evaluation

Max. pulse rate 1 MHz when using quadruple evaluation (differential)

Input range Configurable 5 V differential and 24 V

Position counter

Counter width 32 bit

Speed measurement

Measurement process Gate time measurement with internal 50 MHz cycle

Counter width 24 bit

Minimum detectable speed Pulse duration greater than 0.33 s = speed 0

Encoder supply

Supply 24 V Looped through from 24 V input terminal

Load capacity 100 mA per encoder

Protection Against overload and short circuit

Supply 5 V Produced by 24 V supply via input terminal

Nominal voltage 5.05 V ±4 %

Latch inputs

Number of inputs 2

Response time of latch input 20 μs

Input type Configuration as sink or source input

Galvanic isolation No

Time stamp for latch event

Resolution 1 μs

Max. cycle time 16-bit counter: Unique up to 65 ms cycle time

Dimensions, weight

Height 120 mm

Width 22.5 mm front plate / 32.5 mm incl. K-bus plug

Depth 100 mm

Weight 135 g

General

Supply voltage 24 V DC from front (nominal voltage tolerance: 19.2 V … 30 V, acc. to EN 61131-2)

24 V DC from K-bus, 5 V DC from K-bus

Overvoltage category II

Protection class III acc. to EN 61131-2

Addressing on K-bus Via 16-digit address switch, on the side

Connection terminals Open – pitch: 5.08 mm

Max. power consumption K-bus 24 V 0 W

Max. power consumption K-bus 5 V 0.6 W

Leave a Reply

Your email address will not be published. Required fields are marked *