Foxboro P0972VA Address Translation Station

Interface Card Installation

Your Model H92 workstation is shipped with the configuration that you ordered. If you deter

mine that you need to upgrade any interface cards or other hardware, see Chapter 5 “Installing

Hardware Upgrades” prior to installing any software.

Setting CMOS BIOS Parameters

NOTE

Model H92 workstations are customized to operate correctly with I/A Series Soft

ware from Invensys Foxboro. These changes involve BIOS settings, operating sys

tem parameters, and application services.

The CMOS BIOS parameters vary slightly, depending on which configuration of peripherals you

are using. The following procedure indicates which parameters differ and provides the required

settings for each workstation. These settings are configured at the Invensys Foxboro factory.

Proceed as follows to check and configure the setup parameters for the CMOS BIOS for your

Model H92 Workstation.

1. After turning on the workstation, press F10 to run the BIOS setup.

2. The first BIOS settings page opens. Under the General section, set the current time

and date.

3. Set the parameters on this page to the values listed in Table 1-3.

4. Under the File menu of the BIOS, select Save Changes and Exit.

Menu Selection Value

File > System Information Multisector Transfers\SATA0 Not Installed

Product Name (SKU) HP Z400 Workstation (VS933AV)

QPI Link Speed 4800 MT/s

Memory Size (Total) 4096 MB DDR3/ECC/1066MHZ (4096

MB)

Integrated MAC ############

System BIOS 786G3 v03.19

Boot Block Date 11/10/2009

Chassis Serial Number ##########

Asset Tracking Number ##########

Management Mode ASF

Processor Type Intel ® Xeon® CPU W3520 @ 2.67GHz

Processor Speed 2666MHz (130 W)

Processor Stepping 000106A5 (00000011)

Cache Size (L1/L2/L3) 256KB/1MB/8MB

DIMM (MB) D1:2048 D2:0 D3:2048 D4:0 D5:0 D6:0

File > About System BIOS and Setup Utility

Copyright © 1982-2010

Hewlett-Packard Development Com

pany L.P.

All Rights Reserved

File > System Temperatures CPU-0 31°C; CPU-1 0°C;

Ambient 24°C; Memory 69°C

Fan Tachs

CPU-0 ####rpm; CPU-1 0rpm;

Memory 0rpm; Chipset 0rpm;

Chassis ####rpm; PCI 0rpm

File > Set Time and Date Time (hh:mm) >14:07;

Date (mm/dd/yyyy) 02/02/2011

File > Flash System ROM Select a drive:

USB

File > Replicated Setup Save to Removable Media

Restore from Removable Media

File > Default Setup Save Current Settings as Default

Restore Factory Settings as Default

File > Apply Defaults and Exit

File > Ignore Changes and Exit

File > Save Changes and Exit

Storage > Device Configuration >

SATA Defaults

Multisector Transfers 16

Transfer Mode Max UDMA

Translation Mode Automatic