B&R 2DS100.60-1 electronic drum sequencer Absolut encoder

B&R2DS100.60-1 electronic drum sequencer Absolut encoder

Material number:

2DS100.60-1

Description:

2010 electronic drum sequencer Absolut encoder, SSI/parallel, 16 bit 3 diff. inputs, RS422 level, 100 kHz 3 diff.

outputs, RS422 level, 100 kHz 16 digital inputs 24 VDC, 5 µsec, sink Order terminal block 1 x TB140 separately!

The I/O bus operates e.g. digital and analog I/O modules, positioning modules, intelligent I/O

processors, etc.

If there is insufficient space available on the main rack for your application, further I/O modules

can be operated on up to four expansion racks. This procedure is called local expansion or I/O

bus expansion. Data transfer to these expansion racks is made simultaneously and with secure

protocol.

4.3  System Interface

The system interface is the sum of all I/O modules, i.e. the interface between PLC and the

machine/system being controlled. All B&R SYSTEMS 2005 I/O modules are electrically isolated

from external disturbances using suitable EMC measures (standard EN61131-2). I/O modules

are enclosed (plastic housing), so that the technician cannot come into contact with the

electronics at installation.

The length and structure of the I/O bus can be adjusted to the requirements of the

machine/system. That means the connection points for I/O signals do not have to be in the same

location as the PLCs CPU. Using a combination of local and remote I/O bus segments (remote

I/O) allows the optimal structure to be created for the respective application. I/O modules are

installed on the machine/system where they are needed. Cabling to the PLC kernel is reduced

to a two conductor or fiber optic cable.

4.4  Industrial PC

The combined I/O bus and system bus is multiprocessor-capable and therefore can hold further

computer units capable of dealing with additional tasks.

4.5  Network Capability

Network capability and the possibility to communicate with systems from other manufacturers

have become a must for all industrial controllers. The B&R 2000 PLC family meets many of these

requirements using system-wide and multi-system communication possibilities

4.6  Software Concept

Special attention was given to simple operation and programming. Standard PLC programs run

cyclically, i.e. the program is repeated in a loop. To increase efficiency, the B&R SYSTEM 2000

also offers the possibility to use various tasks with different cycle times. In this way, time critical

program sections (e.g. reaction to trigger signals) can be processed faster than the evaluation

of slower events (e.g. polling keys).

4.7  Programming

Programming is carried out using B&R Automation Studio™. Several programming languages

are available:

• Automation Basic (previously PL2000)

• ANSI C

• IEC 1131 Ladder Diagram (LAD)

• IEC 1131 Sequential Function Chart (SFC)

• IEC 1131 Structured Text (ST)

• IEC 1131 Instruction List (IL)

Differences in data type names between B&R Automation Studio™ and PG2000

The B&R 2005 is made up of individual modules that are housed in plastic. The modules (with

the exception of the power supply and the CPU) can be inserted in any order on a backplane.

The power supply must always be located on both far left slots of the backplanes. The CPU must

be operated directly next to the power supply.

Both the bus system and the supply lines are on the backplane. Backplanes are available in

different lengths (6. 9. 12 and 15 slots).

5.1.1  Mounting the Backplane

The backplane is installed on a mounting rail (DIN EN 50022 – 35 x 7.5 mm). This mounting rail

is attached conductively to the back wall of the switching cabinet.

In addition to mounting rail installation, the backplane can also be screwed directly onto the back

wall of the switching cabinet