KEBA

KEBA / KEBA-AR101 / Circuit Board, Scratch, Rust

Analog inputs (differential or single-ended)

Number of inputs 8

Type Voltage input

Input type Differential (standard setting) or single-ended; freely assignable via software

Signal range Differential: ±10 V; single-ended: 0 – Uref

Reference voltage output Uref 10 V ±2.5 %, max. 20 mA

Max. measurement signal-10.4 V … +10.4 V

Galvanic isolation of the output groups No

Galvanic isolation from the control electronics No

Sensor failure detection Yes

Scan repeat cycle 100 μs

Input impedance in signal range 5 MΩ

Input filter characteristic – order Second order

Input filter transfer frequency 2500 Hz

Digital filters Configurable to: no filter, 500 μs, 1 ms, 5 ms

Resolution 16 bit (±10 V), 15 bit (0 V – Uref)

Conversion method Successive approximation

Monotonicity without error codes Yes

Common mode range ±13.5 V

Common mode rejection ratio > 80 dB

Value of the lowest bit (LSB) 0.325 mV

Maximum permitted continuous load

(without damage) ±30 V

Typ. temp. coefficient measurement error ±5 ppm of scale end value / °C

Max. temp. coefficient measurement error ±20 ppm of scale end value / °C

Largest error at 25 °C ±0.02 % of scale end value

Analog outputs

SCHNEIDER 140NRP95400
SCHNEIDER 140NWM10000
SCHNEIDER 140SDI95300S
SCHNEIDER 140SDO95300S
SCHNEIDER 140XBE10000
SCHNEIDER 140XBP01000
SCHNEIDER 140XBP01600
SCHNEIDER 140XCP51000
SCHNEIDER 140XTS00200
SCHNEIDER 140XTS00500
SCHNEIDER 170INT11003
SCHNEIDER 170PNT11020
SCHNEIDER 416NHM30030
SCHNEIDER 416NHM30030A
SCHNEIDER 467NHP811DP
SCHNEIDER 490NRP95400
SCHNEIDER 8201-5-1
SCHNEIDER 940369

Number of outputs 6

Type Voltage output

Signal range ±10 V

Galvanic isolation of the output groups No

Galvanic isolation from the control electronics No

Permanently short-circuit proof Yes

Conversion cycle 100 μs

Digital resolution 12 bit

Value of the lowest bit (LSB) 5.22 mV

Monotonicity Yes

Load resistance ≥ 1000 Ω

Largest capacitive load ≤ 10 nF

Settling time when changing over the full range ≤ 100 μs

Typ. temp. coefficient analog output error ±20 ppm of scale end value / °C

Max. temp. coefficient analog output error ±30 ppm of scale end value / °C

Largest error at 25 °C ±0.15 % of scale end value

Leave a Reply

Your email address will not be published. Required fields are marked *