MOOG D136-002-004 Ruggedized Motion Controller Interface

Mounting

Installation consists of mounting a horizontal DIN rail to the vertical rear surface of an industrial steel enclosure.

The rail release clips on the G123-814 should face downward to allow front panel and

terminal markings to be clearly readable and to allow cooling airflow to the internal electronics.

An important consideration for module placement is electromagnetic interference (EMI) from other equipment in the enclosure.

For example, VFs and AC servo drives generate high levels of EMI.

be sure to check other equipment for EMC compliance before placing it near the G123-814.

It is recommended that crimped “guide lace sleeves” be used as screw terminals.

Allow sufficient length of cable so that the wires remain connected when the circuit card is removed from the housing.

This allows the circuitry to be checked while the circuit card is still connected and operational.

For cables connected to the outside of the housing as well as for cables connected to the adjacent DIN rail unit, an additional 100 mm is sufficient.

The cable to the valve coil carries 1 Amp and should be sized accordingly.

Cables with a conductor size of 0.2 mm2 are normally rated at 1 Amp and are suitable for cable lengths up to 5 metres.

The length of bare wire should be minimised. Connect the shield at each end of the cable to chassis ground.

This compact brushless Servo Motor is designed to meet the special requirements

of main battle tanks with 2-in-1 stator (double motor) arrangement to accommodate the high power needed.

The brushless servo motor is intended to be integrated into a traverse actuator with a gearbox,

brake and manual input/ auxiliary drive assembly.