B&R  ECCP60-01  MULTI CPU type B 42 KByte SRAM  

B&R ECCP60-01  MULTI CPU type B 42 KByte SRAM

Material number:

ECCP60-01

Description:

MULTI CPU type B 42 KByte SRAM for 42 KB instructions Order PROM application memory separately 1 TTY online interface with electrically isolated receiver Can be used in MULTI/MIDI module racks

7.1.1  Connecting B&R 2005 to B&R 2010

A B&R 2005 expansion backplane is coupled to a B&R 2010 expansion master using a power

supply with expansion slave. The entire configuration can have a maximum of four B&R 2005

expansion backplanes

7.1.2  Connecting B&R 2010 to B&R 2005

A 2010 I/O bus is coupled to the 2005 expansion master using the expansion slave. A maximum

of twenty 2010 I/O modules can be connected in this way

Up to 31 remote slaves can be connected to a remote master (B&R SYSTEM 2005. B&R

SYSTEM 2010 or B&R SYSTEM 2000 Logic Scanner), and the B&R 2003. B&R 2005 and

B&R2010 systems can be combined as desired.

Each remote slave starts a new I/O bus. The maximum number of slots available depends on

the type of slave.

The PROFIBUS (process fieldbus) is an open fieldbus with standardized communication

functions

PLC Modules

The B&R2005 consists of both single-width and double-width modules. The width corresponds

to the number of slots required:

The measurements given are installation measurements. The depth of the backplane must be

added to the total depth of the PLC

The following elements can be found behind the module door:

• Status LEDs

• Node number switch

• Reset button

• Connection plug

Openings are provided in the module door with most modules so that LEDs can be read without

the door being open.

A label strip can be inserted on the inside of the module door which can be seen from the outside

All 2005 backplanes are constructed in the same way. The only difference is the number of slots

available:

A mounting rail, which conforms to the DIN EN 50022 standard, is required for mounting the

PLC. The mounting rail is fastened to the back wall of the cabinet

The installation should only be carried out by qualified personnel!

The installation of the PLC takes place in the following order:

1) Install mounting rail (see Section 3.1 “Grounding the Mounting Rail”, on page 70)

2) Install the backplane

3) Mount the PLC modules

Installing the Backplane

The following steps are to be taken in order to attach the backplane onto the mounting rail:

a) Set all fastening levers to the “OPEN” position.

b) Hang the backplane on the desired position on the mounting rail

c) Set all fastening levers to the “CLOSE” position with a screwdriver. The screw head slot must

be in a horizontal position to guarantee the required contact pressure for proper EMC

characteristics. Turning the fastening lever also places the contact spring under pressure

which creates the proper contact.

Removing backplane modules is done in reverse order

Mount the PLC modules

After the backplane has been fastened securely to the mounting rail, the PLC modules can be

mounted in the appropriate backplane slots. A module is installed in the following order:

a) Using the module support hook, hang the module on the base hook latch of the backplane

To remove PLC modules, follow the same directions in reverse order.

Pressing the module fastening lever (1) will unclip the locking mechanism. The module can then

be tilted forward (2) and removed from the backplane (3)